|
|
|
|
Meet National Electric Code requirements with a Trace DC175 or 250. These modules are designed to link with Trace SW and DR series inverter systems. Battery disconnect: An easy way to isolate inverter and battery Meets National Electrical Code requirement for "means of disconnection." No exposed "hot" terminals Doesn't need ring terminal lugs Overcurrent protection: DC circuit breakers UL listed for up to 125VDC Extremely low voltage drop (less than most fuses or current shunts) Rated for interrupting high fault current (up to 25,000 amps at 65 VDC) Easy to reset No exposed "hot" terminals Room for expansion Optional second main breaker accommodates dual inverter systems Second breaker can be field installed Space allows for DC current shunts Optional bonding block simplifies wiring and grounding Bonds negative conductor to grounding system at single point Lugs to terminate four 4/0, two #1/0, two #2 and four #4 cables Four Auxiliary breaker positions Optional 15-amp DC breaker for small DC loads or equipment room light Optional 60-amp DC-rated breaker for PV array disconnect, charge controller, etc. UL listed for DC systems up to 125 VDC Rated for interrupting high fault current, up to 25,000 amps at 65 VDC Easily accessible #10-32 stud terminals  Trace/Xantrex
has a complete line of DC disconnects and breakers. The high amperage DC breaker
is housed within a powder coated enclosure with conduit knockouts for SW and DR
series inverter connection. The DC disconnects are simple to install and meet
all electrical code requirements for appropriate circuit protection.DC disconnects are expandable, allowing an additional 175 or 250 amp inverter breaker to be installed for dual inverter installations. DC input/output breakers for PV, charge controllers, or DC loads can also be filed installed in a DC175 or DC250. Disconnect and Breaker Options DC250: 250 amp breaker with enclosure DC175: 175 amp breaker with enclosure GJ250: Additional 250 amp breaker (field installable) DCBB: Negative/ground bonding block. Connects up to two #4/0 AWG negative cables and grounding system CD60DC: 60 amp circuit breaker for solar array input disconnect. Mounts on the side of the DC250 or DC175 CD15: 15 amp circuit breaker for small DC loads. Mounts on the side of the DC250 or DC175 CD20: 20 amp circuit breaker for small DC loads. Mounts on the side of the DC250 or DC175
|
|
NORTHWEST POWER CO, LLC Email at:
info@nwpwr.com |
